ARTTEK MPC4

Multi-Protocol Converter - Solution for OPC UA

MPC4 is a multi-PLC protocol converter that eliminates the complicated setting troubles, will not be executed due to job upgrades, and reduces compatibility with other software. Because it supports multiple PLC protocol conversions, it is not easy to be bound by PLC hardware.

MPC4 is also an OPC UA gateway, which avoids the DCOM setting problem, will not be executed due to job upgrade, reduce compatibility with other software, reduce system load and reduce system diagnostic time. Due to the above advantages, maintenance is required. much easier.

The MPC4 communicates with the controller and covers a wide range of communication interfaces in the industry, such as Schneider Modbus Serial & Ethernet, Rockwell Automation Serial, Siemens Ethernet, GE Serial & Ethernet, Mitsubishi Serial & Ethernet.

In addition to the information obtained through the OPC UA Client, the image control or other systems can also exchange data with Wonderware SuiteLink through the OPC UA/DA Client, but do not allow users to make any numerical changes internally, only one-to-one data. Corresponding exchange.

MPC4 can diagnose the communication status of each defined I/O and fully grasp the communication quality.

The MPC4 is fully self-diagnosing, automatically restarts the fault, and provides a record of system operations. Record the controller or device communication status and master the connection information. Time correction is provided to ensure consistent system uptime.

ARTTEK MPC4

 

Ordering information

  • MPC4：4 port RS-232/422/485 can be selected by software
  • OPT1-DB9：D-Sub 9-pin terminal conversion connector; 512/514 applies
  • OPT1I：1 meter RJ45 to DB9 male cable; 518/516 (optional)
  • OPT1J：30 cm RJ45 to DB9 male cable; 518/516 (optional)
  • 1702002600：US standard power connector and 1.8 meter long power cord; 518/516 (optional)